Configuration of AC output ports + DIM


Go to the controller settings

To configure the output ports, you must first go to the controller settings:
● Go to Menu - Device Manager● Select the desired controller from the list and click Setup



Configure output ports

● Select Ports and interfaces and go to the OUT 1 -.... tab● On the tab of the output ports OUT1 -... the outputs of the controller are shown as separate cards● Select the icon of the desired Output


Note: The output numbers on the cards are the same as the physical outputs on the front of the controller.


Select the type of peripheral device

● In the settings window, select "What is connected?"● Select the Device


Important: The list of peripherals that can be connected to this output port will depend on the type of port.


Advanced settings

● Select the advanced Settings icon, here you can specify the value:- Invert - change signal polarity on/off;- Activate energy meter of used energy on port - switching on the load control sensor;- Toggle value - value that will be set after toggle;- Startup value - value that will be set after reboot or port configuration;- Dimming front - leading edge, trailing edge, both;- Fade - time of smooth dimming / illumination of a lamp when switching off / switching on;
● Save the settings by clicking on the icon and return to the settings window of the selected output port


Important: The AC dimmer can be used in relay mode to turn on/off devices. In this case, for the correct operation of the load, it is necessary to set the value of the fade parameter equal to 0.

Note: Advanced settings always contain default data. Changing the values in the advanced settings is an optional step if necessary.


Choosing a room

● In the field "Where the device is located" you can specify the location of the device● If you need to add a new room, click on the "+" icon located in the upper right corner of the screen, assign a name to the new room, set its type and click on the Save icon 


Note: If you leave this field blank, the location of the peripheral device will be displayed as "not specified", and the Dashboard window will indicate that it is located in the room "----------".


Name the device

● Return to the Settings window of the selected output port● In the Name field, for convenience, you should specify the name of the device by which you can uniquely identify it● Click the Save icon


Note: If the device name is not specified, the system will assign the default name to the device.

The result of the described steps:

● Created a device connected to a specific Output, with a user-specified name and basic settings. You can see and control this device by going to the Dashboard tab.● It will also be available in the What to manage field when creating or editing automation section.

Didn’t find the answer to your question?

You can contact the technical support chatbot.Found a mistake on the site? Help us fix it!

Made with